Section 8 - Cooling System - Group 08 Fan Hub (Belt Driven) - Rebuild (8-04) M11 Page 8-25 Remove the front bearing. Use a punch and hammer to remove the rear bearing outer race. NOTE: Use care not to damage the inside bore of the hub as the bearing race is removed. Turn the hub over in the vise so the back side is facing up. NOTE: Use care not to damage the inside bore of the hub when removing the race. Use a hammer and punch to remove the front bearing outer race and large bearing spacer. NOTE: Inspect the bearing retaining ring. If the ring is not damaged, it does not need to be removed. Cleaning Use solvent to clean the fan hub assembly parts. Dry with compressed air.