Engine Disassembly (0-01) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-22 Engine - Installation On Rebuild Stand Use the engine rebuild stand, Part No. 3375194, and adapter plate, Part No. 3376432. Use five capscrews (5/8—11 X 2 inch) grade 5 capscrews to install the adapter plate to the rebuild stand. Torque Value: 180 [135 ft-lb] Install two guide pins, Part No. 3376488, in the water header plate mounting capscrew holes at points (1) and (2) (No. 3 capscrew hole from each end). Warning: To avoid personal injury, use a properly rated hoist to lift the engine. The engine weighs approximately 940 kg [2070 lb]. Use the engine lifting fixture, Part No.
3822512, to lift the engine. Install the exhaust side of the engine to the adapter plate of the rebuild stand. Align the top of the adapter plate (3) to the top row of the water header plate mounting capscrews holes (4). The cylinder block must be positioned so two capscrew holes (5) and (6) in the bottom row will show on each side of the adapter plate. Align the guide pins with the bottom row of holes in the adapter plate at points (7) and (8). Use eight capscrews, Part No. 3376434, to install the adapter plate to the engine block. Torque Value: 47 [35 ft-lb] Remove the guide pins and install two capscrews, Part No. 3376434. Torque Value:
47 [35 ft-lb] Lifting Brackets - Removal Remove the front lifting bracket. Remove the rear lifting bracket.