Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-72 Flywheel - Installation Install one guide pin, Part No. 3376696, into the crank- shaft flange. NOTE: On REPTO units, install the crankshaft gear on the guide pin before installing the flywheel. This component weighs 23 kg [50 lb] or more. To avoid personal injury, use a hoist or get assistance to lift the component. The crankshaft flange must be clean and free of damage. Install the flywheel on the guide pin. Install the engine barring tool, Part No. 3824270, to the flywheel. Caution: Capscrew length is critical.
Capscrews of dif- ferent length can result in loss of flywheel integrity that can cause engine damager and personal injury. Install seven capscrews: Standard Flywheel Housing (M14-1.50 x 35) REPTO Flywheel Housing (M14-1.50 x 110) Remove the guide pin and install the one remaining capscrew. Tighten the capscrews in a star pattern. Torque Value: 183 [135 ft-lb] Flywheel Bore Runout - Measurement Use the dial indicator gauge (1), Part No. 3376050, and the dial gauge attachment (2), Part No. ST-1325, to check the flywheel bore (3) and face (4) runout. Install the attachment to the flywheel housing. Install the gauge on the attachment.
Install the contact tip of the indicator against the inside diameter of the flywheel bore.