Camshaft, Balancer Shafts and Timing Gear Train/Camshaft FUEL SUPPLY PUMP REAR CAM INSTALLATION Some engine models have the fuel supply pump actuated by a cam (A) fitted at the rear of camshaft. When ordering a new camshaft, also order the fuel supply pump rear cam. Install the cam using a press. CD30436 -UN-10MAY95 CD,3274,G20,45 -19-01FEB94 CTM3274 (01JUL99) 20-12 Saran Liter Engines 060799 PN=135 INSTALL CAMSHAFT -UN-16JUN98 CD30596 1. Before installation of the tachometer drive shaft 4. Install cap screws (D) and tighten to 50 N·m (35 (A), check the diameter of the knurled shaft area (B). lb-ft).
If diameter exceeds 12.92 mm (0.5087 in.), rework shaft to 12.88—12.92 mm (0.5071—0.5087 in.). IMPORTANT: To keep the initial working condition between cam lobes and cam 2. Coat camshaft with clean engine oil. On engines followers, always replace cam with camshaft bushing, lubricate the inner followers (E) when installing a new circumference of bushing with TY6333* grease. camshaft. 3. Install camshaft and thrust plate (C) in cylinder block. *Available as service part. CD,CTM125,116 -19-01DEC97 20 12