Camshaft, Balancer Shafts and Timing Gear Train/Gear Train OIL DEFLECTOR INSTALLATION Install oil deflector (A) and O-ring (B) when equipped on crankshaft. NOTE: Oil deflector is not used on engine with crankshaft-gear-driven (37 kW) auxiliary drive option. CD30608 -UN-04MAY98 CTM3274 (01JUL99) 20-30 Saran Liter Engines CD,3274,G20,32 -19-04JAN99 060799 PN=153 AUXILIARY DRIVE GEAR INSTALLATION (37 KW) NOTE: Oil deflector is not used on engines with 37 kW auxiliary gear drive. 1. Lubricate outer and inner circumferences of collet (A) with engine oil. Slide collet onto crankshaft with large -UN-03AUG92 end toward crankshaft gear (B). Position collet against the gear. 2.
If equipped, slip rubber O-ring onto crankshaft and position against front edge of collet. RG6339 NOTE: O-ring was previously installed against collet. On more recent engines the O-ring (D) is installed on the special washer (E). 3. Lubricate inner circumference of the auxiliary drive gear (C) with engine oil and place on collet (with recessed side of gear toward crankshaft pulley). -UN-10MAY95 4. Using JDG794 tool, push drive gear onto collet by tightening the nut of special tool to 150 N·m (110 lb-ft) to seat the gear. CD30403 A—Collet B—Crankshaft gear C—Auxiliary drive gear D—O-ring (to be installed on washer) E—Special washer CD,3274,G20,39 -19-04JAN99 20 30