Camshaft, Balancer Shafts and Timing Gear Train/Timing Gear Cover INSTALLATION OF TIMING GEAR COVER FOR 37 KW AUXILIARY DRIVE 1. Position new gasket on front plate. Make sure gasket surfaces on cover and front plate are clean. 2. Install cover with new built-in crankshaft front oil seal onto engine. CD30174 -UN-07MAR95 3. Install the timing gear cover cap screws, nuts and washers and tighten to 50 N·m (35 lb-ft). Be sure to install the three cap screws and washers (A) located behind the auxiliary idler and securing the cover to the front plate and engine block.
CD,3274,G20,40 -19-01FEB94 CTM3274 (01JUL99) 20-34 Saran Liter Engines 060799 PN=157 INSTALL CRANKSHAFT FRONT OIL SEAL -UN-04MAY98 -UN-16JUN98 CD30611 CD30698 1. Place new seal onto KJD10164 Seal Installer (A) NOTE: KJD10164 tool set contains also a spacer (C) with open side toward engine, then slide the to be used only on old applications with short assembly onto crankshaft nose. nose crankshaft (35 mm length). 2. Install pulley cap screw with washer (B), then tighten until driver bottoms. CD,CTM125,129 -19-01DEC97 20 34