PERIODIC SERVICE 60 B Replacing Transmission Oil Filter To avoid personal injury: A Be sure to stop the engine before changing the oil filter cartridge. A Allow engine to cool down sufficiently, oil can be hot and can burn. 1. Remove the drain plug at the bottom of the transmission case and drain the oil completely into the oil pan. 2. Check the rubber washer on the drain plug. Replace it if missing or in poor condition. 3. After draining, reinstall the drain plug. 4. Remove the oil filters. 5. Put a film of clean transmission oil on the rubber seal of the new filter. 6.
Quickly tighten the filter until it contacts the mounting surface, then, with a filter wrench, tighten it an additional 2/3 turn only. 7. After the new filter has been replaced, fill the transmission oil up to the upper notch on the dipstick. 8. After running the engine for a few minutes, stop the engine and check the oil level again, add oil to the prescribed level. 9. Make sure that the transmission fluid doesn't leak past the seal on the filters. (1) Drain plug (1) Oil inlet (2) Dipstick (A) Oil level is acceptable within this range A To prevent serious damage to the transmission, use only a KUBOTA genuine filter.
(1) Transmission oil filter (HST) (Yellow color) (2) Transmission oil filter (Suction) (Orange color)