213 213 LEFT AUGER ANCHOR DRIVE REF NO. PART NUMBER QTY DESCRIPTION REMARKS 1. 149-895 1 HYD MOTOR 500-390 SEAL REPAIR KIT - REAR 500-391 SEAL REPAIR KIT - SHAFT 107-792 BOLT (5/16"X 1-5/8", DBL HEX) 165-900 KEY (7/16" SQ X 1.250") 105-917 CASTLE NUT (1-1/4-NF) 502-177 SHAFT AND BEARING ASS'Y SEE FOOTNOTE 1 500-2123 FRONT RETAINER (ANCHOR MOTOR) 2. 150-747 2 CYLINDER ASSEMBLY 3. 125-771 2 COMPOSITION BUSHING (1.25") 4. 183-765 2 TAPERED PIN (31.7MM X 110MM) 5. 181-982 2 TAPERED INSERT (1.25") 6. 106-469 2 FLG SCREW (M12-1.75 X 30MM) 7. 359-799 1 MAST 8. 106-685 23 LOCKNUT(M12-1.75,PRV TRQ,10.9) 9. 106-471 4 FLG SCREW (M16-2.00 X 30MM) 10. 309-194 4 CLAMP PLATE 11. 309-195 8 GLIDE STRIP 12.
309-203 4 CARRIAGE SPACER BAR 13. 106-335 14 SCREW (M12-1.75 X 70MM) 14. 309-206 1 BULKHEAD PLATE 15. 125-773 2 COMPOSITION BUSHING (1.75") 16. 309-209 1 ARM 17. 106-700 2 SCREW (M12-1.75 X 80MM) 18. 309-204 1 BULKHEAD PLATE 19. 309-582 - FLANGED HEX DRIVER 20. 178-881 1 FLANGE 21. 105-245 8 SCREW (M10-1.50 X 25MM) 22. 106-397 9 WASHER (M12, HARDENED) 23. 105-279 1 CARRIAGE BOLT (1/2-NC X 3") 24. 105-501 1 COTTER PIN (1/8" X 2") 25. 105-071 1 WASHER (1/2") 26. 105-833 1 FLG LOCKNUT (1/2-NC) 27. 110-531 1 HANDLE (1/2-NC, BLACK) 28. 309-602 1 ANCHOR HANGER 29. 106-333 2 SCREW (M12-1.75 X 40MM, 8.8) 30. 106-594 4 SCREW (M12-1.75 X 60MM) 31. 309-207 1 MOTOR MOUNT 32.
179-239 1 TAPERED PIN (44.4MM X 288MM) 33. 181-975 1 TAPERED INSERT (1.75") 34. 106-470 1 FLG SCREW (M16-2.00 X 40MM) USE LOCTITE 242 USE LOCTITE 242 USE LOCTITE 242 USE LOCTITE 242 USE LOCTITE 242 NOT SHOWN: FOOTNOTES: 1. TORQUE NUT TO 375 FT. LB. DRY OR 275 FT. LB. LUBED NOTE: 15 ID0045620