10 Fieldwork settings 10.6 Crop receptacle / straw receptacle 67086 83409 10.6.4 Bolting down the free-swinging knives Observe the general warnings at the beginning of the "Fieldwork settings" chapter. Danger! Risk of injury from sharp knives. Always wear gloves to avoid injuries when removing and installing the knives. Arrest the cutting cylinder so it will not rotate. 33 Danger! 28806 Use of unauthorised spare parts. Death or severe injuries, machine damage. Use genuine CLAAS spare parts. Note! Uneconomic use of machine. Machine damage. The knives must not jam, but must move freely. Operate the cutting cylinder only with a complete set of knives in each case.
4 2 4 2 Bolt on free-swinging knives for grain: Two free-swinging knives (grain) must be bolted to each mounting plate (H) as shown in figure. Mount hex. bolts (1) from the outside to the inside, facing the machine centre (M). Tightening torque: Bolts with Dacromet coating M 10 - 10.9 = 55 Nm M 1 5 Observe decal on the cutting cylinder! 3 H 3 34 28775 Install the straw guide plate. 188 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 Designation 1 Hex. bolt ISO 4014 - M 10 x 55 -10.9 2 Bushing D 30 x 10 3 Free-swinging knife (grain) 4 Bushing D 30 x 11 5 Self-locking nut ISO 7042 VM 10 -10 H Mounting plate M Machine centre