13 Maintenance 13.6 Chassis 67089 86622 13.6.13 Adjusting the chassis clutch DOMINATOR 130 Observe the general warnings at the beginning of the "Maintenance" chapter. Unhinge rods (1 and 2) at lever (3). Pull rod (1) to the outside until a resistance is clearly felt and adjust the pre-set dimension (C = 40 mm) from the inner edge of the nut up to the side panel. 2 1 C 72 23386 Fit rods (1 and 2) to lever (3), using pin (4). Depress the clutch pedal until a clear resistance is felt, measure the play (A = 7 - 11 mm) and adjust at rod (1) if required. Note: The play should be set to the upper tolerance limit (10 - 11 mm).
Depress the clutch pedal to the maximum, meas- ure the overall clutch path (B = 20±1 mm) and adjust at rod (2) if required. 2 1 A Caution B 73 Incorrect installation of components. 23386 Increased wear on components or machine damage. The yokes (5) of rods (1 and 2) must not touch lever (3) either when operated or when in rest position. Observe the adjusting dimensions. Ensure that the overall clutch path is (B = 20±1 mm). 86746 13.6.14 Adjusting the short-circuit valve DOMINATOR 130 Observe the general warnings at the beginning of the "Maintenance" chapter. 316 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09