13 Maintenance 13.8 Drive belts / drive chains 67089 87288 13.8.5 Adjusting belt (R2) E 3 X 1 D Z 2 R2 A B Y C Observe the general warnings at the beginning of the "Maintenance" chapter. 29951 82 Danger! Parts can be thrown off by a relaxing spring. Serious injuries. Precisely follow the following handling instructions. Adjust the spring-loaded cylinder (1): - Ensure that spring-loaded cylinder (1) is mounted in the rear hole (E). - Adjust spring guide tube (2) with the front attachment engaged until dimension (X) is around 20 mm . Adjust nut (3) at the same time and jam with the spring guide tube. Check dimension (X). Adjusting the belt guide:
- Adjust belt guides at position (A, B, C and D) so with the front attachment engaged that the fol- lowing dimensions result between belt back and belt guide. Dimension (Y) = 5 - 7mm , dimension (Z) = 4 mm - Tighten all the bolts. Carry out a test run and check belt tension. 324 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09