5 Prior to initial operation 5.5 Feeder unit 67081 5.5 Feeder unit 79358 5.5.1 Fitting / adjusting the mounting plates Observe the general warnings at the beginning of the Prior to initial operation chapter. DANGER! The front attachment is not sufficiently secured. Death or serious injury. Comply precisely with procedure instructions. Check the safe locking of the front attachment. Bolt down mounting plate (4) hand-tight on both sides of the machine. Fit front attachment. Pull out cotter pin at position (A). Slide lock pin (2) up into the feeder unit opening of the machine, using lever (3). Secure lever (3) in position (B), using the cotter pin.
Slacken off mounting plate (4) and slide it as closely to the lock pin (2) as possible. Bolt down mounting plate (4). 3 4 B 2 A 9 19523 89422 5.5.2 Aligning the coupling pin F The front attachment must be parallel with the drive axle of the machine. To achieve this, the coupling pins must be aligned. Drive the machine with the front attachment fitted on a flat and level surface. Check the alignment. The finger bar must be par- allel with the ground while the machine stands on a flat and level surface. If necessary, put down the front attachment. Slacken off coupling pins (1) and raise or lower the pins so that the finger bar is parallel with the ground on a flat and level surface.
10 19525 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 95