Lighting system 85 Tail lamp Licence plate lamp Driver's workstation Tail lamp, right The licence plate lamp is behind the reflector unit. X Remove screws : . X Remove the lamp lens. X Remove reflector units ; and ? . X Applying light pressure, turn bulb = anti- clockwise and remove it. X Insert new bulb = and turn clockwise, applying light pressure. X Insert reflector units ; and ? . Tail lamp, left : Screws ; Perimeter/side marker lamps = Turn signal lamps ? Brake lamp A Reversing lamp B Rear lamps C Rear foglamp X Attach the lamp lens. X Tighten screws : .
Perimeter lamp You cannot change bulbs for turn signal lamps, tail lights, brake lights or perimeter lamps in vehicles with LED modules. If nec- essary, have these bulbs replaced at a quali- fied specialist workshop. X Remove screws : . X Remove screw ; . X Remove the lamp lens. X Turn the bulb anti-clockwise, applying light pressure, and remove it. X Swing housing : of the perimeter lamp outwards slightly and remove it. X Insert the new bulb and turn clockwise, applying light pressure. X Applying light pressure, turn bulb = anti- clockwise and remove it. X Attach the lamp lens. X Tighten screws : . X Insert new bulb = and turn clockwise, applying light pressure. Z