John Deere 450DLC — Engine Control Module (ECM) Circuit Theory of Operation

TM2361 (24JUN08) 9015-15-16 450DLC Excavator Operation and Tests 062608 PN=460 Sub-System Diagnostics Camshaft position sensor (B2) detects TDC of cylinder When the fuel pressure exceeds the delivery valve #1 and provides backup for the crankshaft position opening pressure, the fuel is routed to the common sensor should it malfunction. The camshaft position rail, distributing fuel to electronic injectors 1—6 (Y1— sensor is installed on the high pressure fuel pump and Y6). sends a signal to the ECM (terminal E98) when the cam portion of the camshaft passes the sensor.

The Fuel Injection Amount—The ECM controls the fuel ECM supplies a 5-volt reference voltage (terminal E87) injection amount based on actual engine speed and and ground (terminal 101) for the camshaft position target engine speed. The ECM determines actual sensor. engine speed using signals received from the crankshaft position sensor. Main controller (A3) Pressure Sensors—Fuel rail pressure sensor (B12) determines target engine speed using signals received detects fuel pressure in the common rail. The fuel rail from engine speed dial (R15) and various pressure pressure sensor is installed on the common rail and sensors and switches.

The main controller uses the sends a varying signal to the ECM (terminals E82 and controller area network (CAN) to send the target E90). The varying signal represents the varying engine speed information to the ECM. resistance of the fuel rail pressure sensor corresponding to the common rail pressure. High NOTE: For additional information on engine speed resistance of the sensor indicates a low pressure. The control, see Main Controller (MCF) Circuit ECM supplies a 5-volt reference voltage (terminal E87) Theory of Operation. (Group 9015-15.) and ground (terminal 101) to the fuel rail pressure sensor.

After receiving the target engine speed information 9015 15 16 from the main controller, the ECM compares the target Barometric pressure sensor (B3) detects atmospheric speed with the actual engine. The ECM varies the fuel pressure and sends a varying signal to the ECM injection amount by controlling how long electronic (terminal V71). The varying signal represents the injectors 1—6 (Y1—Y6) are activated and deactivated. varying resistance of the barometric pressure sensor corresponding to the atmospheric pressure.

The ECM Fuel Injection Timing—The ECM controls fuel injection supplies a 5-volt reference voltage (terminal V61) and timing based on engine speed and fuel injection ground (terminal V60) for the barometric pressure amount. The camshaft and crankshaft position sensors sensor. allow the ECM to precisely determine piston position in relation to TDC so that the ECM can activate the Fuel Injection Pressure—The ECM determines the correct electronic injector at the correct time. appropriate fuel injection pressure based on engine speed, fuel injection amount, and common rail Fuel Injection Rate—To improve combustion in the pressure.

The ECM controls fuel injection pressure by cylinders, the ECM injects a small amount of fuel (pilot activating and deactivating fuel pump control valve injection) into the cylinder. After this pilot injection solenoids 1 and 2 (Y15 and Y16) using pulse width ignites, the ECM injects the main supply of fuel. modulation (PWM). When the fuel pump control valve solenoids are deactivated, fuel is allowed to flow into Fuel Injection Amount Correction—The ECM adjusts the pumping chambers. When the ECM activates the the fuel injection amount based on atmospheric fuel pump control valve solenoids, the valve to the conditions. After the engine starts, if the engine speed pumping chamber is closed.

This prevents any fuel is less than engine start correction speed (550 rpm), from flowing into the pumping chambers. The high the ECM adjusts the fuel injection amount. The ECM pressure fuel pump raises the pressure of the fuel in adjusts the fuel injection amount based on signals the chamber to the required pressure for injection. received from the barometric pressure sensor. Continued on next page CS33148,00008EA –19–21APR06–3/4