Sub-System Diagnostics Slow = 8 second delay (1.5 volts) Middle = 6 second delay (2.5 volts) Fast = 3 second delay (3.5 volts) be routed to both sides of the wiper motor to ensure the wiper motor does not operate until when needed again. Windshield Wiper Park Operation— When windshield wiper and washer switch (S9) is turned to the OFF position, the windshield wiper relay de-energizes, but the wiper motor continues to run because the internal status switch provides a ground to the wiper motor through terminals S and L and the normally closed contacts of the now de-energized wiper relay.
When the wiper reaches the PARK position (far left side of the windshield), a cam in the wiper motor mechanism opens the internal status switch, which disconnects the wiper motor from ground and causes the wiper motor to stop. Windshield Washer Operation— Pushing the momentary windshield wiper and washer switch (S9) sends a ground signal to terminal B3 of the monitor controller. When the monitor controller detects this signal at terminal B3, the monitor controller connects terminal A10 to ground, which energizes windshield washer relay (K9).
With the windshield washer relay energized, current flows from windshield wiper and washer 10 amp fuse (F2), across the relay contacts (terminals 3 and 5) to windshield washer motor (M6), activating the motor. At the same time, the internal status switch connects wiper motor terminals S and L, which allows power to 9015 15 39 LD30992,0000215 –19–27APR06–3/3 TM2361 (24JUN08) 9015-15-39 450DLC Excavator Operation and Tests 062608 PN=483