TM2361 (24JUN08) 9015-20-110 450DLC Excavator Operation and Tests 062608 PN=600 References Engine Control Module (ECM) Remove and Install 1. Disconnect battery ground (-) cable. 2. Remove cap screws (1) and ECM cover (2). –UN–28APR06 3. Disconnect electrical connectors (3). 6 4. Remove cap screws (4) and remove ECM (5) from TX1005242 mounting bracket. ECM Location 5. Replace parts as necessary. IMPORTANT: When replacing engine control unit, new software must be loaded before installation. 6. Place ECM (5) in mounting bracket. Install cap screws and tighten to specifications.
9015 20 ,110 Specification Mounting Bracket Cap Screw— Torque....................................................................................1—1.24 N•m 9—11 lb-in. 7. Reconnect electrical connectors (3) to ECM. –UN–19APR06 8. Install ECM cover. Install cap screws and tighten to specifications. Specification TX1005244A Mounting Bracket Cap Screw— Torque....................................................................................1—1.24 N•m 9—11 lb-in. ECM Cover 9. Connect battery ground (-) cable. 10. Program injectors. See Injector ID Code Registration.
(Group 9010-25.) 1—Cap Screw (4 used) 2—ECM Cover –UN–27MAR06 3—Connectors 4—Cap Screw (4 used) 5—Engine Controller (ECM) 6—ECM Location TX1005246A ECM Continued on next page AH91621,00002A8 –19–01MAY06–1/2