John Deere 450DLC — Replace (Pull Type) Metri-Pack™ Connectors

TM2361 (24JUN08) 9015-20-124 450DLC Excavator Operation and Tests 062608 PN=614 References Replace (Pull Type) Metri-Pack Connectors Disconnect the Metri-Pack1 connector (A). Remove tie bands and tape. Insert a “T” pin (B) 6.4 mm (1/4 in.) into connector body –UN–26APR89 socket (C). NOTE: Use JDG7772 Terminal Extraction Tool or “T” pin to remove terminals. RW16933 Angle “T” pin so pin tip slides close to the plastic socket edge pushing terminal locking tab (D) inward. Remove “T” pin and push terminal (E) out of socket. Remove terminal, cut strip and crimp wire through connector.

–26APR89 Check to make sure locking tab on new terminal is in outward position, then pull on wire until terminal locks in 9015 20 ,124 connector body socket. –UN RW16934 NOTE: Terminal will seat only one way. If terminal does not pull into the connector body socket, check to make sure terminal is aligned correctly. A—Connector B—“T” Pin C—Body Socket D—Locking Tab E—Push Terminal –UN–26APR89 RW16935 1Metri-Pack is a trademark of Packard Electric 2Included in JT07195A Electrical Repair Kit LD30992,0000242 –19–31MAR06–1/1