John Deere 450DLC — Noisy or Loose Track Chain Diagnostic Procedure

Group 15 Diagnostic Information Diagnose Undercarriage Components Malfunctions NOTE: Diagnose malfunction charts are arranged from most probable and simplest to verify, to least likely and most difficult to verify. TX19495,0000001 –19–27APR06–1/1 Noisy or Loose Track Chain Diagnostic Procedure –1/1 TM2361 (24JUN08) 9020-15-1 450DLC Excavator Operation and Tests 062608 PN=629 1 Track Sag Check Check track sag. See Check and Adjust Track Sag. (Operator’s Manual.) Is track sag within specification? YES: Go to Track Shoe Check. NO: Adjust track sag. – – –1/1 9020 15 1 2 Track Shoe Check Inspect track shoes for missing or loose cap screws. See Check Track Shoe Hardware.

(Operator’s Manual.) Are all track shoes cap screws in place and tight? YES: Go to Track Adjuster Check. NO: Remove loose track shoes to clean material from between shoe and link. Install track shoes and tighten cap screws in proper sequence. See Track Shoe Remove and Install. (Group 0130.) – – –1/1 3 Track Adjuster Check Inspect if grease fitting and valve are tight and not leaking grease or oil. Are grease fitting, valve and seal properly installed? YES: Diagnostic procedure complete. NO: Replace grease fitting or valve. To replace seals, see Track Adjuster Cylinder Disassemble and Assemble. (Group 0130.) – – –1/1