TM2361 (24JUN08) 9025-05-111 450DLC Excavator Operation and Tests 062608 PN=749 Theory of Operation Return Filter Operation Return Filter Operation—The filter element (1) is located in a chamber inside the hydraulic oil tank. O-rings are used at each end of the filter element to prevent leakage. A spring holds the filter element on its seat. Return oil from the oil cooler (3) and the control valve (4) flow through the filter element from the outside to the center. Filtered oil flows out the bottom of filter into the hydraulic oil tank. Bypass Valve—A bypass valve (2) is located at the top of the filter.
The bypass valve opens to protects the filter –UN–25APR06 element (1) against pressure surges in the return circuit and allows a path for return oil if the filter element becomes plugged. During bypass operation, oil flows into the chamber faster than it can flow through the filter TX1007018 element causing the pressure to increase. The higher pressure forces the bypass valve open allowing oil to flow down the center of the filter element and into the hydraulic Return Filter Operation oil tank. The bypass valve closes when the pressure decreases below the pressure setting of the bypass valve.
1—Filter Element 2—Bypass Valve 3—From Oil Cooler 4—From Control Valve –UN–25APR06 TX1007019 Bypass Operation LD30992,000026C –19–25APR06–1/1 9025 05 ,111