TM2361 (24JUN08) 9025-15-4 450DLC Excavator Operation and Tests 062608 PN=754 Diagnostic Information 1 Pilot Pressure Regulating Valve Check Use monitor service menu to display Arm-In Pilot Pressure. See Monitor Service Menu Operation. (Group 9015-16.) NOTE: To test with remote gauge, perform Pilot Pressure Regulating Valve Test and Adjustment. (Group 9025-25.) Run at fast idle and move arm-in function full travel and hold over relief. Record pressure. Is the pilot pressure above 3.7 MPa on monitor when function is held over relief? YES: Go to Engine Speed Check. NO: Go to Pilot Regulating Valve Inspection.
– – –1/1 2 Pilot Regulating Valve Inspection See Pilot Pressure Regulating Valve Remove and Install. (Group 3360.) Remove and inspect pilot pressure regulating valve. Is the pilot valve in good condition? YES: Adjust pilot pressure regulating valve. Perform Pilot Pressure Regulating Valve Test and Adjustment. (Group 9025-25.) NO: Go to Pilot Filter Check. – – –1/1 3 Pilot Filter Check Remove and inspect pilot filter. Is pilot filter clogged or contain excessive metallic debris? YES: If non-metallic debris, clean filter. If excessive metallic debris, remove and inspect pilot pump. NO: Diagnostic procedure complete.
– – –1/1 9025 15 4 4 Engine Speed Check Key on, use monitor service menu to display EC Dial Angle voltage. See Monitor Service Menu Operation. (Group 9015-16.) Start engine and turn auto idle off. Observe monitor as engine speed as dial is moved from slow to fast idle. Does E C dial angle voltage change from approximately 0.5—4.4 volts and does engine speed increase to fast idle? YES: Go to Main Relief Valve Check. NO: See Engine Speed Control System Operation. (Group 9010-05.) – – –1/1