John Deere 450DLC — Hydraulic Oil Overheats Diagnostic Procedure

Diagnose Hydraulic Overheating Malfunctions MR50960,00000F1 –19–26MAY06–1/1 Hydraulic Oil Overheats Diagnostic Procedure IMPORTANT: Wrong viscosity oil can cause overheating, check oil for correct temperature range. See Hydraulic Oil. (Operator’s Manual.) –1/1 TM2361 (24JUN08) 9025-15-8 450DLC Excavator Operation and Tests 062608 PN=758 Diagnostic Information 2 Pump Flow Rate Valve Spool Check See Pilot Signal Manifold Operation. (Group 9025-05.) Remove and inspect pump 1 or pump 2 flow rate pilot valves. Do flow rate pilot valve spools move freely? YES: Diagnostic procedure complete. NO: Repair or replace pilot signal manifold flow rate pilot valve spool.

See Pilot Signal Manifold Disassemble and Assemble. (Group 3360.) – – –1/1 1 DTC Check See Reading Diagnostic Trouble Codes With Monitor Display. (Group 9015-20.) See Reading Diagnostic Trouble Codes With Service ADVISORDiagnostic Application Are any of the following DTC displayed? • 11004.02 See CAN Communication Error. (Group 9001-10.) • 11412.03 See Hydraulic Fan Pump Control Solenoid Valve Feedback Current High. (Group 9001-10.) • 11412.04 See Hydraulic Fan Pump Control Solenoid Valve Feedback Current Low. (Group 9001-10.) • 11901.03 See Hydraulic Oil Temperature Sensor Circuit Voltage High. (Group 9001-10.) • 11901.04 See Hydraulic Oil Temperature Sensor Circuit Voltage Low.

(Group 9001-10.) • 110.03 See Engine Coolant Temperature Sensor Voltage High (P0118). (Group 9001-10.) YES: Diagnose and repair as required to clear displayed DTC. Diagnostic procedure complete. NO: Go to Fan Speed Control Check. – – –1/1 9025 15 8 2 Fan Speed Control Check Run engine at slow idle and remove harness connector at fan control solenoid on top of fan pump. Does fan increase to maximum speed? YES: Go to Oil Cooler Bypass Valve Check. NO: Go to Fan Drive Control Pressure Check. – – –1/1