John Deere 450DLC — All Hydraulic Functions Low Power Diagnostic Procedure

Diagnostic Information Function Moves in Opposite Direction Diagnostic Procedure –1/1 All Hydraulic Functions Low Power Diagnostic Procedure –1/1 TM2361 (24JUN08) 9025-15-16 450DLC Excavator Operation and Tests 062608 PN=766 1 Pilot Hose Routing Check See Control Lever Pattern Conversion. (Operator’s Manual.) Check pilot control hose connections at pilot valve, pilot signal manifold and hydraulic valve. See Pilot Control Valve-to-Pilot Signal Manifold Component Location—Excavator Pattern. (Group 9025-15.) or See Pilot Control Valve-to-Pilot Signal Manifold Component Location—Backhoe Pattern. (Group 9025-15.) Are pilot control hoses connected correctly? YES: Diagnostic procedure complete. NO:

Correct pilot control hose connections. – – –1/1 Diagnose Dig Circuit Malfunctions NOTE: If function operating speeds are very slow also, perform All Hydraulic Functions Slow Diagnostic Procedure first. (Group 9025-15.) IMPORTANT: Make sure hydraulic oil level, condition, and type of oil is checked before doing this procedure. 9025 15 16 • Hydraulic oil temperature, cold oil can slow hydraulic functions. • Low oil level can cause pump cavitation, see Check Hydraulic Tank Oil Level. (Operator’s Manual.) • Suction side air leaks will cause oil to foam or become aerated. Inspect site glass oil condition. • Wrong viscosity oil can cause pump cavitation, see Hydraulic Oil.

(Operator’s Manual.) MR50960,00000F7 –19–26APR06–1/1