Dig Function Speed Is Slow During Combined Operation With Swing Diagnostic Procedure –1/1 TM2361 (24JUN08) 9025-15-27 450DLC Excavator Operation and Tests 062608 PN=777 Diagnostic Information 3 Circuit Relief Valve Check Key on, use monitor service menu to display Pump 1 or Pump 2 Delivery Pressure. See Monitor Service Menu Operation. (Group 9015-16.) Put power mode switch on HP and work mode on digging. Run engine at fast idle and operate each digging function over relief. Record pressure. Do all circuit relief valve above 30.4 MPa? YES: Go to Boom Circuit Leakage Check. NO: Adjust or repair circuit relief. Perform Circuit Relief Valve Test and Adjustment.
(Group 9025-25.) – – –1/1 4 Boom Circuit Leakage Check TX1006310 –UN–12APR06 Leakage Test Position bucket and arm as shown with bucket cylinder fully retracted. 1. Relieve hydraulic pressure from boom circuit. 2. Remove rod end hoses from both boom cylinders. 3. Drain oil from hoses and cap hose ends with high pressure plugs. 4. Leave cylinder rod end ports open and place container under them to catch any excess oil. 5. Start engine and slowly retract arm cylinder so bucket is approximately 300 mm (12 in.) off ground Does oil leak out of rod end of boom cylinder? YES: Repair boom cylinder piston seals. NO: If boom lowers and no oil leaks out of rod end ports, the control valve is leaking.
Inspect and repair control valve. See Control Valve Disassemble and Assemble. (Group 3360.) – – –1/1 9025 15 27