John Deere 450DLC — Swing Speed Slow or Does Not Operate In One Direction Diagnostic Procedure

TM2361 (24JUN08) 9025-15-33 450DLC Excavator Operation and Tests 062608 PN=783 Diagnostic Information 5 Flow Rate Pilot Valve Check See Pilot Signal Manifold Operation. (Group 9025-05.) Inspect pump 1 or pump 2 flow rate pilot valves. Do flow rate pilot valve spools move freely? YES: Go to Pump 2 Flow Check. NO: Repair or replace pilot signal manifold flow rate pilot valve spool. See Pilot Signal Manifold Disassemble and Assemble. (Group 3360.) – – –1/1 6 Pump 2 Flow Check Perform Cycle Times Check. (Group 9005-10.) Check travel cycle times. Slow travel cycle times may indicate worn pump. If travel cycle times do not meet specification, check pump flow. Perform Pump Flow Test.

(Group 9025-25.) Do travel cycle times and pump flow meet specification? YES: Diagnostic procedure complete. NO: Repair or replace pump. See Pump Remove and Install. (Group 3360.) – – –1/1 Swing Speed Slow or Does Not Operate In One Direction Diagnostic Procedure IMPORTANT: If dig and travel functions normally, the pilot pump is considered to be ok. If all functions are slow, perform All Hydraulic Functions Slow Diagnostic Procedure first. (Group 9025-15.) – – –1/1 9025 15 33 1 Actuating Pilot Pressure Check Key on, use monitor service menu to display Swing / Attachment Control Pilot Pressure. See Monitor Service Menu Operation. (Group 9015-16.) NOTE:

Spool actuating pressure can be checked for each function by installing a tee and gauge in pilot line and then actuating that function. Perform Control Valve Spool Actuating Pilot Pressure Test. (Group 9025-25.) Run engine at fast idle and operate problem function. Observe pressure when function held over relief. Is pilot pressure above 3.70 MPa? YES: Go to Park Brake Release Pressure Check. (Group 9025-15.) NO: Go to Pilot Valve Check. – – –1/1