John Deere 450DLC — Machine Mistracks During Combined Operation With Dig Functions Diagnostic Procedure

TM2361 (24JUN08) 9025-15-46 450DLC Excavator Operation and Tests 062608 PN=796 Diagnostic Information 2 Flow Combiner Signal Pressure Check 1 2 3 TX1006257 –UN–12APR06 1—Pilot Signal Manifold 2—To Bucket Flow Rate Control Valve 3—To Travel Flow Combiner Valve Disconnect travel flow combiner hose from port (3) and install pressure gauge. Run engine at fast idle and record signal pressure. Is pressure approximately 3.9 MPa, (3900 kPa) (39 bar) (570 psi)? YES: Repair or replace flow combiner valve control spool in signal control valve. See Pilot Signal Manifold Disassemble and Assemble. (Group 3360.) NO: Go to Load Check Valve. – – –1/1 3 Load Check Valve See Control Valve Operation.

(Group 9025-05.) Inspect load check valve for damage. Is load check in good working condition? YES: Go to Travel Motor Leakage Check NO: Repair or replace load check valve. See Control Valve 5-Spool Disassemble and Assemble. (Group 3360.) – – –1/1 9025 15 46 4 Travel Motor Leakage Check Perform Travel System Tracking Check. (Group 9005-10.) Check tracking while descending a hill. If tracking is within specification when descending a hill, but not when on the level or going up hill, travel motor leakage is indicated. If tracking does not meet specification, check travel motor leakage. Perform Travel Motor Leakage Test. (Group 9025-25.) Does tracking and motor leakage meet specification? YES:

Go to Rotary Manifold Leakage Check. NO: If travel motor leakage does not meet specification, repair or replace travel motor. See Travel Motor and Park Brake Disassemble and Assemble. (Group 0260.) – – –1/1