Travel Mode Will Not Switch From Slow To Fast Speed Diagnostic Procedure –1/1 TM2361 (24JUN08) 9025-15-47 450DLC Excavator Operation and Tests 062608 PN=797 Diagnostic Information 5 Rotary Manifold Leakage Check Perform Rotary Manifold Air Test. (Group 0260.) Inspect rotary manifold for leakage. Is rotary manifold OK? YES: Diagnostic procedure complete. NO: Repair or replace rotary manifold. See Rotary Manifold Disassemble and Assemble. (Group 0260.) – – –1/1 1 DTC Check See Reading Diagnostic Trouble Codes With Monitor Display. (Group 9015-20.) See Reading Diagnostic Trouble Codes With Service ADVISORDiagnostic Application Are any of the following DTC displayed?
• 11405.03 See Travel Speed Solenoid (SI) Valve Current Feedback High. (Group 9001-10.) • 11405.04 See Travel Speed Solenoid (SI) Valve Current Feedback Low. (Group 9001-10.) • 11991.03 See Travel Right Pilot Pressure Sensor Circuit Voltage High. (Group 9001-10.) • 11991.04 See Travel Right Pilot Pressure Sensor Circuit Voltage Low. (Group 9001-10.) • 11993.03 See Travel Left Pilot Pressure Sensor Circuit Voltage High. (Group 9001-10.) • 11993.04 See Travel Left Pilot Pressure Sensor Circuit Voltage Low. (Group 9001-10.) YES: Diagnose and repair as required to clear displayed DTC. Diagnostic procedure complete. NO: Go to Travel Mode Selector Switch Check.
– – –1/1 9025 15 47 2 Travel Mode Selector Switch Check Key on, use monitor service menu to display Travel Mode Switch. See Monitor Service Menu Operation. (Group 9015-16.) Turn the high speed mode on and check if display indicator is on. Does indicator change from L to H? YES: Go to Motor Speed Control Pressure Check.. (Group 9025-15.) NO: Go to Harness Check. – – –1/1