Travel Park Brakes Do Not Apply Diagnostic Procedure –1/1 TM2361 (24JUN08) 9025-15-48 450DLC Excavator Operation and Tests 062608 PN=798 Diagnostic Information 3 Harness Check See System Functional Schematic, Wiring Diagram, and Component Location Master Legend. (Group 9015-10.) Check for open in harness between switch and main controller. Does harness have open wire? YES: Repair or replace harness. NO: Replace travel mode switch. – – –1/1 4 Motor Speed Control Pressure Check Key on, use monitor service menu to display Travel Pilot Pressure. See Monitor Service Menu Operation. (Group 9015-16.) Set travel to fast mode observe travel pilot pressure on monitor.
Is maximum pressure approximately 3.9 MPa? YES: Go to Servo Piston Shuttle Valve Check NO: Diagnose monitor controller. See Main Controller (MCF) Diagnostics Using Dr. ZX. (Group 9015-20.) – – –1/1 5 Servo Piston Shuttle Valve Check See Park Brake Valve Housing Disassemble and Assemble. (Group 0260.) Inspect servo piston shuttle valve. Does shuttle valve operate correctly? YES: Inspect Travel Reduction Gear Check. NO: Repair or replace motor swash plate angle control. See Travel Motor Cover Disassemble and Assemble. (0260.) – – –1/1 9025 15 48 6 Travel Reduction Gear Check See Travel Gearbox Disassemble and Assemble. (Group 0250.) Inspect travel reduction gear.
Is reduction gear in good condition? YES: Remove and inspect travel motor for damage. NO: Replace gear. – – –1/1