Diagnostic Information Diagnose Counterweight Removal System Malfunctions MR50960,00000F8 –19–25APR06–1/1 Counterweight Removal / Installation Device Does Not Operate Or Low Power Diagnostic Procedure –1/1 TM2361 (24JUN08) 9025-15-58 450DLC Excavator Operation and Tests 062608 PN=808 1 DTC Check See Reading Diagnostic Trouble Codes With Monitor Display. (Group 9015-20.) See Reading Diagnostic Trouble Codes With Service ADVISORDiagnostic Application Are any of the following DTC displayed? • 11404.03 See Power Dig Solenoid (SG) Valve Feedback Current High. (Group 9001-10.) • 11404.04 See Power Dig Solenoid (SG) Valve Feedback Current Low. (Group 9001-10.) YES:
Diagnose and repair as required to clear displayed DTC. Diagnostic procedure complete. NO: Go to Wiring Connector Check. – – –1/1 2 Actuating Pilot Pressure Check Key on, use monitor service menu to display Attachment Control Pilot Pressure. See Monitor Service Menu Operation. (Group 9015-16.) NOTE: Spool actuating pressure can be checked for each function by installing a tee and gauge in pilot line and then actuating that function. Perform Control Valve Spool Actuating Pilot Pressure Test. (Group 9025-25.) Record actuating pilot pressure for counterweight release function. Is pilot pressure above 3.70 MPa? YES: Go to All Hydraulic Functions Low Power Diagnostic Procedure.
(Group 9025-15.) NO: Go to Pressure Sensor Swap Check. – – –1/1 9025 15 58 3 Pressure Sensor Swap Check Switch counterweight sensor with other pilot pressure sensor. Does symptom go away? YES: Replace counterweight sensor. NO: Go to Voltage Check – – –1/1 4 Voltage Check See System Functional Schematic, Wiring Diagram, and Component Location Master Legend. (Group 9015-10.) Remove pressure sensor connector and measure voltage on terminal #1 with key on. Does terminal #1 measure 4.5—5.5 V? YES: Go to Harness Check. NO: Repair or replace harness to repair open. – – –1/1