TM2361 (24JUN08) 9025-15-59 450DLC Excavator Operation and Tests 062608 PN=809 Diagnostic Information 5 Harness Check See System Functional Schematic, Wiring Diagram, and Component Location Master Legend. (Group 9015-10.) Remove harness connector (D) from main controller. Connect terminal #3 of connector (D) to machine. Check for continuity between terminal #2 of harness end of connector of pressure counterweight sensor and machine. Is continuity measured? YES: Go to Control Valve Spool Check. NO: Repair or replace harness – – –1/1 6 Control Valve Spool Check See Control Valve Operation. (Group 9025-05.) Inspect control valve spools. Are control valve spools in good working condition? YES:
Replace pilot valve for counterweight. NO: Repair or replace spools in control valve See Control Valve Disassemble and Assemble. (Group 3360.) – – –1/1 Counterweight Removal / Installation Speed Is Too Fast Diagnostic Procedure IMPORTANT: If all other dig functions are fast, perform All Hydraulic Function Too Fast Diagnostic Procedure before doing this procedure. (Group 9025-15.) – – –1/1 9025 15 59