John Deere 450DLC — Control Lever Pattern Conversion

TM2361 (24JUN08) 9025-15-75 450DLC Excavator Operation and Tests 062608 PN=825 Diagnostic Information NOTE: DO NOT use manufacturer’s hose tags or 9. Install a -6 M 37° x -6 M 37° union to fabricated markings on hose ends to identify hoses for hose. Connect union to pilot line disconnected from this conversion procedure. The conversion the shockless valve must be done on the side of digging sensor manifold that is connected to the pilot control 10. Route fabricated hose to digging sensor manifold. valves. 11. Disconnect pilot line from port 6. Port numbers on digging sensor manifold are given from front to rear of machine and are not 12. Connect fabricated hose to port 6. marked on manifold.

13. Route pilot line disconnected from port 6 to the 6. Switch pilot lines connected to port 2 and 5 at shockless valve. Connect line to port B. digging sensor manifold (9). 14. Install covers. 7. Disconnect pilot line from port B of the boom shockless valve (10). 8. Use the following table to fabricate the hydraulic hose needed. Part Number Description Assembly Quantity X10643-6-6 Fittings 2 X421-6 Hydraulic Hose, No 1905 mm (75 in.) Skive Left Fitting: X10643-6-6 (Parker No. 10643-6-6) Right Fitting: X10643-6-6 (Parker No. 10643-6-6) Hydraulic Hose: X421-6 (Parker No. 421-6) Cut Length: 1885.4 mm (74.23 in.) Crimp Dies: 43-6 (YEL) Die Ring: Silver Length:

1949.9 mm (76.77 in.) GD61784,0000058 –19–26OCT06–6/6 9025 15 75 Part Number Description Assembly Quantity X10643-6-6 Fittings 2 X421-6 Hydraulic Hose, No Skive 1905 mm (75 in.) Left Fitting: X10643-6-6 (Parker No. 10643-6-6) Right Fitting: X10643-6-6 (Parker No. 10643-6-6) Hydraulic Hose: X421-6 (Parker No. 421-6) Cut Length: 1885.4 mm (74.23 in.) Crimp Dies: 43-6 (YEL) Die Ring: Silver Length: 1949.9 mm (76.77 in.)