MBE 900 OPERATOR'S GUIDE OPERATION Important: Before starting the engine, do all the recommended pretrip inspections and daily maintenance. Check the engine oil and fuel levels, and drain contaminants from the fuel/water separator (optional). noises, or shows an unusual loss of power, turn the engine off as soon as possible and determine the cause. Frequently, engine damage may be avoided by a quick response to early indications of problems. If you are starting the engine in cold weather, refer to "Cold Weather Products" in the “Service Products” section of this manual. Before Starting the Engine NOTE: If you drain the fuel/water separator completely, you may have to prime the fuel system.
Checking the Batteries Use only batteries that have been correctly filled and serviced. To provide corrosion protection, apply dielectric grease, part number 48-02349-000, liberally to the terminal pads. Approved suppliers are listed in Table 1. Be sure you are familiar with all of the instruments, gauges and controls which are needed to operate the engine. Note especially the location and function of the following:
Oil Pressure Gauge Coolant Temperature Gauge Low Oil Pressure/High Coolant Temperature Warning Light Water In Fuel Warning Light Tachometer Air Restriction Indicator Table 1 Approved Electrical Lubricants When starting the engine, and while driving, watch for any signs of engine problems. If the engine overheats, uses excessive fuel or lubricating oil, vibrates, misfires, makes unusual All information subject to change without notice. (Rev. 04/08) 31 DDC-SVC-MAN-0055 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION Manufacturer Lubricant or Part Number Shell Oil, Co. No. 71032; No. 71306 Texaco, Inc. No. 955 Quaker State No. NYK-77