99 FUEL TANK REF NO. PART NUMBER QTY DESCRIPTION REMARKS 1. 194-165 1 FUEL TANK 2. 110-563 3 SPRING CLAMP (3/8") 3. 156-268 1 FUEL STRAINER (04H) 194-505 1 FUEL PICKUP (04H) BEGINS WITH S/N 4. 364-567 1 FILL NECK 153-760 1 CAP 153-594 2 GASKET, FILL NECK CAP SEE FOOTNOTE 3 153-607 1 FLANGE GASKET 153-761 1 FLANGE 107-781 6 HEX SCREW (#10-24 X 5/8") 153-606 1 STRAINER BASKET 5. 156-269 2 S/O COUPLER (04H-05H90) 6. 110-528 4 SNAP-ON CLAMP (.531" TO .593") 8. 319-484 1 COVER 7. 106-387 4 FLG LOCKNUT (M10-1.50) BEGINS WITH S/N ____________. 9. 116-108 AR BULK HOSE (5/16", SOLD PER 1") 10. 116-108 AR BULK HOSE (5/16", SOLD PER 1") USE 1 @ 65" USE 1 @ 51" 11.
214-650 1 FUEL SENDER 165-704 1 GASKET 13. 106-558 4 CLIP NUT (M10-1.50) 12. 116-325 2 GROMMET (.362") 14. 156-108 1 S/O COUPLER (08N-08H90) 16. 116-322 AR BULK HOSE (1/2",SOLD PER 1") 15. 110-217 1 WORM CLAMP(7/16" TO 1") USE 1 @ 48" 17. 111-021 1 BREATHER CAP (TANK) 18. 105-818 2 BOLT (1/4-NC X 1-1/2") 19. 110-411 1 BOLT-ON CLAMP (3/4", SET) 20. 322-289 1 BACKUP (BOLT-ON) USE 1 @ 24" USE 1 @ 20" 23. 114-002 1 PLUG (06N, SOC) 21. 118-096 AR BULK FUEL TUBING (1/4", PER FT) 22. 118-096 AR BULK FUEL TUBING (1/4", PER FT) 24. 105-829 2 FLG LK BOLT(1/2 NC X 1") 25. 106-386 2 FLG LOCKNUT (M8-1.25) NOT SHOWN: FOOTNOTES: 1.
ARRANGE LINER PADS IN AN EVEN PATTERN ON INTERIOR SURFACES OF THE SIDE PLATES, BOTTOM PLATE AND KICK PLATE. USE .12 THICK AND .25 THICK TO PROVIDE A SNUG FIT FOR THE ONCE FILLED THE TANK SHOULD NOT SHIFT. TANK. APPLY AND ADJUST THE LINER PADS UNTIL THE LEAST MOVEMENT POSSIBLE HAS BEEN ACCOMPLISHED. 2. LAYER SUPPORT MAT BETWEEN LEDGE OF TANK AND UNDERSIDE OF STEP UNTIL FIRM PRESSURE IS REQUIRED TO ALIGN SLOTS AND INSERT SCREWS 3. ORIENT PADLOCK LUGS AWAY FROM STAIRWELL NOTE: 12 ID0029262