147 HYDROSTATIC PUMP LINKAGE ENDS WITH S/N____________. 1. 315-735 1 REAR SUPPORT (AUX DRIVE PUMP) REF NO. PART NUMBER QTY DESCRIPTION REMARKS 2. 110-318 2 BALL JOINT (#10-32, FM) 3. 106-678 6 LOCKNUT (1/4-NF) 4. 194-196 - CONTROL CABLE (116") 6. 105-106 1 BOLT (1/4-NC X 2") 5. 315-484 1 CAM PLATE SEE FOOTNOTE 1 8. 315-483 1 PUMP TRUNNION LEVER 7. 106-386 1 FLG LOCKNUT (M8-1.25) 9. 105-810 2 BOLT (#10-24 X 7/8", SOC) 10. 106-205 2 WASHER (.191") 11. 331-166 1 BOLT-ON BACKUP (.360") 12. 110-697 1 BOLT-ON CLAMP (.360") 13. 107-092 3 WASHER (.254") 15. 179-301 1 BRONZE BUSHING (.375) 14. 106-528 4 SCREW (M6-1.00 X 20mm, SOC) SEE FOOTNOTE 2 17. 125-491 1 CAM YOKE ROLLER BEARING 18.
117-614 4 FRICTION WASHER (.781") 19. 105-699 2 BOLT (1/4-NF X 1-1/4") 16. 116-142 2 SHOCK MOUNT SEE FOOTNOTE 2 20. 181-636 1 BUSHING 21. 106-989 1 FLG LK SCREW (M8-1.25 X 35mm) 23. 313-954 1 CABLE CONNECTOR 22. 179-302 1 SLEEVE (.250) 25. 105-069 2 WASHER (.406") 26. 105-047 2 LOCKNUT (3/8-NC) 27. 105-811 2 LOCKNUT (#10-24) 24. 217-269 1 PROXIMITY SWITCH 28. 105-162 2 BOLT (3/8-NC X 2-1/4") 30. 315-646 1 PROXIMITY SWITCH MOUNT 29. 315-536 1 INNER CONTROL ARM 32. 107-516 2 CLIP NUT (M4-.7) 31. 107-268 4 SCREW (M4-0.70 X 20mm, SOC) 33. 105-680 2 NUT (M4, W/LK WSHR) 34. 107-597 4 WASHER (M4) NOT SHOWN: FOOTNOTES: 1.
TO ATTACH BRACKET (REF #5) USE THE TWO INSIDE BOLTS LOCATED IN THE REAR OF THE FRONT PUMP ON THE SAME SIDE AS THE TRUNION SHAFT. 2. APPLY LOCTITE BEFORE ASSEMBLY. NOTE: 04 ID0139933