MBE 900 ENGINE 2007 OPERATOR'S GUIDE OPERATING INSTRUCTIONS FOR STARTING THE ENGINE Following are instructions for starting the engine. oil, vibrates, misfires, makes unusual noises, or shows an unusual loss of power, turn the engine off as soon as possible and determine the cause. Frequently, engine damage may be avoided by a quick response to early indications of problems. First Time Start Preparation When preparing to start a new or newly overhauled engine which has been in storage, perform all of the operations listed below. Also refer to the ENGINE STORAGE section of this guide. Failure to follow these instructions may result in serious engine damage.
If you are starting the engine in cold weather, refer to "How to Select Coolant" in the “HOW-TO SECTION” section of this guide. System Checks Be sure you are familiar with all of the instruments, gauges and controls which are needed to operate the engine. Perform the following system checks before starting for the first time. Cooling System Checks Note especially the location and function of the following: Check the cooling system as follows: Oil Pressure Gauge 1. Make sure all drain cocks in the cooling system are installed (drain cocks are often removed for shipping) and are closed tightly.
Coolant Temperature Gauge Low Oil Pressure/High Coolant Temperature Warning Light Water In Fuel Warning Light 2. Remove the radiator pressure control cap and fill with genuine Detroit Diesel POWER COOL ® antifreeze or an equivalent quality ethylene glycol or propylene glycol-base antifreeze solution in the required concentration. In extremely hot environments, properly inhibited water may Tachometer Air Restriction Indicator When starting the engine, and while driving, watch for any signs of engine problems. If the engine overheats, uses excessive fuel or lubricating All information subject to change without notice. (Rev.
04/08) 21 DDC-SVC-MAN-0040 0704 Copyright © 2008 DETROIT DIESEL CORPORATION