. OPERATION EXPLANATION OF COMPONENTS OPERATION EXPLANATION OF COMPONENTS the screw again. (The lever is installed to position (B) when it is shipped from the factory.) right. 3 - 51 REMARK The length of the lever can b e adjusted to 3 stages (positions (A), (B), (C)). To adjust the lengt h, remove the screw at the bottom of the lever knob, slide the kno b to the desired position, then tighten AUTOMATIC SHIFT Automatic gear shifting can be carried out in the 2nd through 4th speed range of the four forwa rd and reverse speeds depending on the travel conditions. Position (a): 1st Position (b): 2nd Position (c): 3rd Position (d):
4th The range of speeds during automatic gear shifting is determined by the position of the gearsh REMARK The 1st position for the ge arshift lever fixes the transmission in 1st. There is no automati c shifting of the transmission. When shifting down from 2 nd to 1st, press the kick-down switch on the lift arm control leve r. If the transmission is in au to-shift and the travel speed is below 12.5 km/h (7.8 MPH) in either forward or in rever and makes it possible to s This makes it easy to carr any speed range when traveling in se, the kick-down switch is actuated hift down to 1st. y out load and carry operations.
Even if the travel speed is more than 12.5 km/h (7.8 MPH), this switch can be used to shi the kick-down switch is pre one range at a time (whe F3 -> F2). ft the transmission down. Each time ssed, the speed range will shift down n in 4th: F4 -> F3 -> F2; when in 3rd: