. OPERATION EXPLANATION OF COMPONENTS OPERATION EXPLANATION OF COMPONENTS (The lever is installed to position (B) when it is shipped from the factory.) 3 - 52 To set to the desire d speed range when traveling uph ill or downhill, or when carrying o ut grading, do as follows When fixing the Press the HOLD The speed rang transmission ind switch on the lift arm co ntrol lev e is fixed at the speed r played When shifting up or down from set spee Shift gear with th REMARK When the transmis sion has been shifted do wn from 2nd to 1st with the kickdown switch, it will shift up from 1st to 2nd when the trave l speed increases.
DIRECTIONAL LEV ER This lever (2) is use d to switch the direction of travel o f the machine between forward a nd reverse. engine, if the directional lever is not at the N e will not start. When starting the position, the engin In this case, the ce ntral warning lamp will light up and the buzzer t lever to the N position and start the engine. ARD AL RSE ght up a nd the buzzer will sound. Return the gearshif t lever to the N position and star t the engin Position (a): FORW Position N: NEUTR Position (b): REVE REMARK The length of the le ver can be adjusted to 3 stages (positions ( A), (B), (C)).
To adjust the length, remove the screw at the bottom of the lever knob, slid e the knob to the desire d positio n, then tighten the screw again. GEARSHIFT LEVER STOPPER This stopper (3) pr events the gearshift leve r from en tering the 3rd or 4th positions wh en working. er actuated. er released. Position (a): Stopp Position (b): Stopp