. MAINTENANCE SERVICE PROCEDURE EVERY 100 HOURS SERVICE LUBRICATE REAR AXLE PIVOT PIN (3 places) 1. Using a grease pump, pump in grease through the grease fittings marked by the arrows. CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL WARNING engine is stopped, and may cause burns. Wait for the 1. Lower the bucket horizontally to the ground and stop the 4 - 43 Maintenance f or every 50 hours service should be ca rried out at the s ing, wipe off any old grease that was pushed o The parts an d oil are at high te mperatur e immediately temperature t o go down before s tarting the When removi ng the oil filler cap, turn it slo wly to release the intern ait for 5 minutes, then che ck sight gau ge (G).
ould be between the H an NOTICE If the oil has bee n added to above H level, stop the engine and wait for hydraulic oil to c ool down, then drai n the exce ss oil from the drain plug the oil is above to spurt out. H level, it will damage the hydraulic circuit or cause th below the L level , open th e inspection cover ab ove the step and add oil throu gh oil filler port (F)