. MAINTENANCE SERVICE PROCEDURE LUBRICATING (1) (2) (3) (4) Bucket pin (2 places) Bucket link pin (2 places) Dump cylinder pin (2 places) Lift cylinder pin (4 places) (5) (6) (7) Lift arm pivot pin (2 places) Bell crank pin (1 place) Steering cylinder pin (4 places) 4 - 50 1. Using a grease pump, p ump in grease through the grease fittings marked by t 2. After greasing, wipe off any old grease that was pushed NOTICE On jobsites where there is a lot of heavy-duty work, or on jobsites where operations are car ried out continuously for more than eight hours, reduce the greasin g interval and carry out greasing