24. SERVICE PROCEDURE 24.5.3 CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL ¤ WARNING There is danger that the oil may spurt out under internal pressure, so to the side, and gradually turn the plug to release the internal pressure before removing the plug completely. 1. Place the machine on a horizontal place. 2. Remove oil level plug G and check whether the final drive case is filled with oil to lower edge of the plug hole. 3. If the oil level is still too low, add gear oil through oil level plug hole G until the oil overflows. Before removing oil level plug G , remove all the mud and dirt from around oil oil level plug G . Be careful not to let any dirt or sand get in when adding oil. 3-55