. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Engine Oil Pan, Add Oil WARNING Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil 3. Fully insert dipstick (G) into filler pipe (F), then remove it. 3 - 66 temperature to go down before per forming this op 1. Open the engine hood on t 2. Remove dipstick (G), and w ipe the oil off 4. The oil le vel should be betw een the H and L marks on d ipstick (G). If the oil filler (F). level is below the L mark, add engine oil through oil gine oil level is higher than the H mark, drain the hrough drain plug (P), and check the level again. 5.
If the en excess t hrough drain plug ( P), and check the level agai 6. If oil leve l is correct, securel y tighten the o il filler cap and close the engin e hood. through oil REMARK ing the oil level after the engine has been operated, When check wait for at l checking. east 15 minutes after stopping the engine before before I f the machin e is at an angle, ma ke it to a horiz ontal position before checking.