. OPERATION MACHINE OPERATIONS AND CONTROLS REMARK 3 - 74 (D) Adjusting ar Armrest (4) can be made to spring up by hand appro In addition, by tu rning the bottom (5) o f the armrest by hand it is possib le to make fine verti cal adjustments of the armrest angle. Armrest adjustm If the seat ba ck is tipped to the fron t without raisin g the armrest(4), a rmrest will rise auto If the cable at the rear of armrest ( 4) is tense (wh en the sea t back is tipped to the front), armrest (4) cannot be rning bottom (5).
W hen adjusting t he angle o f armrest (4), set the seat ba ck to a position where arry out operations, th en adjust the (E) Overall fore- and-aft adjustment of Pull up lever(6), set to the desired pos ition, then rele ase the le ver(6). In this case, the opera tor seat, left and right control levers, an d lock lever all slide t Fore-and-aft adj ustment: 120 mm (4.8 (F) Adjusting sus pension (if equipped ) suspension harder, or to the left to make the suspen Turn knob (7) to the right to make the suspension h the left to make the suspen reading of the di al to match the opera tor's weight an d select th e optimu m suspension.
REMARK To obtain the op timum adjustment, tur n the knob so that the in dicator o f the weight display ( kg) in the transparent portion of knob ( 7) is the same as the operator's wei ght. Rearview Mirrors NOTICE Depending on the direction that the mirror is facing, it may extend outs the swing radius (a pprox.100 mm (3.9 in)). Sit in the operato r's seat and adjust th e mirror so that it is possi to see the right s ide of the counterwei ght.