Operation few minutes. Otherwise fuel may leak. ECM00241 NOTICE UP Before tilting the outboard motor, stop the engine by following the procedure on page 47. Never tilt the outboard mo- tor while the engine is running. Severe damage from overheating can result. Do not tilt up the engine by pushing the tiller handle (if equipped) because this could break the handle. ZMU04146 3. Pull the tilt support lever toward you to support the engine. WARNING! After tilting the outboard motor, be sure to support it with the tilt support knob or tilt support lever. Otherwise the out- board motor could fall back down suddenly if oil in the power trim and tilt unit or in the power tilt unit loses pressure.
[EWM00262] NOTICE: Do not use the tilt support lever or knob when trailering the boat. The outboard mo- tor could shake loose from the tilt support and fall. If the motor cannot be trailered in the normal running po- sition, use an additional support de- vice to secure it in the tilt position. For more detailed information, see page 53. [ECM01641] EMU32723 Procedure for tilting up (power trim and tilt models) 1. Place the remote control lever in neutral. N ZMU03196 2. Press the power trim and tilt switch “ (up) until the outboard motor has tilted up completely. ZMU03432 4. Models equipped with trim rods:
Once the outboard motor is supported with the tilt support lever, press the power trim 50