Optional Equipment - Section 6 OM6007 2/99 Page 6-14 Payload Meter II 5. Press the MODE switch once.The display will show. Refer to "Setting The Operator ID" on Page 18 to change operator. Setting "PL:00" 1. Press and hold the LIGHT/INC and MODE switches. The display will show. 6. Press the MODE switch once. The display will show."SP:62" should be displayed. The speed limit should be set to 62 to avoid unnecessary faults and warnings. Refer to "Setting The Speed Limit" on Page 17 to make adjustments. 2. Press and hold the LIGHT/INC and TOTAL/SFT switches. The display will show. 3. Press the CAL/CLR switch once. The display will show. 7. Press the MODE switch once. The display will show.
Refer to "Setting The Option Code" on Page 17 to change the option. 4. Press the CAL/CLR switch once. The display will show. 8. Press the MODE switch once. The current time should be dis- played with the minutes flashing. Refer to "Setting The Time And Date" on Page 18 to change the time and date. 5. Press the LIGHT/INC switch until "PL:00" is displayed. ONLY "PL:00" IS RECOMMENDED. 6. Press the MODE switch. The display will show. 9. Push the MODE switch to return to normal opera- tion. Checking the Service Check Mode 7. Press MODE and the meter will return to normal operation.
Checking the G T setting Refer to Pages 23 and 24 for additional information on UP Factor and PL Modeprior to setting these values. The G t value must be set = 1.000. Refer to "Calculation Method" on Page 8 for display and adjustment infor- mation. Checking the Inclinometer Settings Setting "UP:00" 1. Press and hold the LIGHT/INC and MODE switches. The display will show. Refer to "Calculation Method" for instructions to dis- play truck pitch angle. With truck on level ground, properly charged suspensions, and empty the display should indicate 0.0 ± 1.0. Remember this is not a live display. After adjustment, Service Check Mode must be entered again to obtain a new reading. 2.
Press and hold the LIGHT/INC and TOTAL/SFT switches. The display will show. An alternative method is to use a Personal Computer running the Komatsu Payload Download Program for windows. The "Monitor Pressures" section of the pro- gram displays live inclinometer data. The inclinometer can be loosened and adjusted until the live display shows 0.0 ± 1.0 degrees with the truck on level ground, properly charged suspensions, and empty. 3. Press the CAL/CLR switch once. The display will show. 4. Press the LIGHT/INC switch until "UP: 0" is displayed. ONLY "UP: 0" IS RECOMMENDED. 5. Press MODE. The display will show. Another method is to use a voltmeter to read the voltage output of the inclinometer.
With the truck on level ground, properly charged suspensions, and empty, the output voltage should be 2.6 ± .1 volts. 6. Press MODE and the meter will return to normal operation.