OM4006.1 06/98 Maintenance - Section 4 Lubrication and Service Page 4-3 10 HOUR (DAILY) INSPECTION Prior to each operating shift, a ‘‘walk around’’ inspec- tion should be performed. Check the truck for general condition. Look for evidence of hydraulic leaks; check all lights and mirrors for clean and unbroken lenses; check operator’s cab for clean and unbroken glass; check frame, sheet metal and body for cracks. Notify the proper maintenance authority if any discrepancies are found. Give particular attention to the following:
Truck Serial Number ____________________________ Site Unit Number ______________________________ Date:______________Hour Meter_________________ Serviceperson Name___________________________ CHECK ALL FLUID LEVELS a. Engine Oil- Note: Refer to engine manufacturer service man- ual for oil recommendations. b. Radiator - Check coolant level and fill with proper mixture as shown in Cooling System Recommendation Chart. c. Battery - Check electrolyte level and add water if necessary. d. Steering, Brake Oil Tank - Check oil level in tanks, add if necessary. Lube key ‘‘C’’. Refer to ‘‘Hydraulic Tank Service’’, page 4-10. e. Hoist & Brake Cooling Oil Tank - Use Lube key ‘‘C’’.
Refer to ‘‘Hydraulic Tank Service’’, page 4-10. NOTE: Check oil level with truck level, engine STOPPED, body down, and oil warm. Oil should be visible in sight glass. - DO NOT OVERFILL . f. Transmission - Check oil level. Add oil, if necessary. Lube key ‘‘C’’. Refer to ‘‘Transmission Oil Level Check’’, page 4-1. g. Fuel Tank - Fill as required. h. Differential - Truck should be on level surface, oil level should be even with plug hole or at plug hole. Refill with oil as necessary. Lube key ‘‘B’’. COMMENTS √’d INITIALS