MACHINE OPERATIONS AND CONTROLS OPERATION GENERAL OPERATION INFORMATION 3 Traveling Traveling over boulders, tree stumps, or other obstacles will cause a big shock to the chassis (and in particular to the tracks), and this will cause damage to the machine. For this reason, always remove any obstacles or travel around them, or take other steps to avoid traveling over such obstacles as far as possible. If there is no way to avoid traveling over an obstacle, reduce the travel speed, keep the work equipment close to the ground, and try to travel so that the center of the track passes over the obstacle.
High Speed Travel On uneven roadbeds, such as rockbed or uneven roads with large rocks, travel at low speed. When traveling at high speed, set the idler at the front of the machine. q Press travel speed selector switch (1) to select the travel speed. Permissible Water Depth NOTICE When driving the machine out of water, if the angle of the machine exceeds 15°C, the rear of the upper structure will go under water, and water will be thrown up by the radiator fan. This may cause the fan to break. Be extremely careful when driving the machine out of water. Do not drive the machine in water deepen than of the center of carrier roller (1).
Supply grease to the parts which have been under water for a long time until the used grease is projected out of the bearings (around the bucket pin, in particular). 3-96