ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT REMARK If groove (A) is facing in the direction shown in the diagram on the right, it is in the lock position. Selector Valve 6 NOTICE Stop the engine and lower the work equipment and chassis to the ground to set in a stable position before carrying out the operation. Switch the position of valve (2) to match the type of attachment. Use a wrench to turn the rotor of the selector valve to the appropriate position. A sticker using arrows to indicate the direction of the ports is fixed to the head of the rotor. This valve (2) selector the flow of the hydraulic oil. Position (a): When using breaker Position (b):
When using general attachment (crusher, etc.) After changing the position of the valve, lock it in position with stopper bar (1). Attachment Control Pedal 6 Do not carry out operations with your foot on the pedal. If the pedal is depressed by mistake, the attach- ment may suddenly move and cause a serious accident. Lock the pedal with the lock pin when you are not operating the attachment. This pedal (3) is used to operate the attachment. (a): Pedal for attachment system 1 (used to operate the breaker). KS000029 6-9 WARNING