SUPER LONG FRONT BOOM AND ARM ATTACHMENTS AND OPTIONS TRANSPORT & STORAGE OF SUPER LONG FRONT MACHINE 6 INSTALLATION OF SUPPORTING LINK 6 q For transportation or storage, always use the supporting link to secure the arm and boom as shown. This will help to prevent excessive force bearing on the boom and arm. Supporting link - weight 30 kg q Other precautions for transport and storage can be found in the section “TRANSPORTATION” of the standard machine manual. Procedure for installing link 1. Lower the boom and extend the arm cylinder to set in the stow posture. 2.
When the arm cylinder is almost at the end of the stroke, lower the boom slowly to bring the bucket or bucket link into light contact with the ground. 3. Remove the A end of the supporting link from the boom (held by a pin), then install it to the arm with the pin. When doing this, raise the boom slightly and retract the arm cylin- der slightly from the end of its stroke (5 mm - 10 mm) to align the holes correctly. Supporting link Boom 4. It is dangerous to carry out this operation with the arm raised from the ground.
Snap ring Arm Pin TRANSPORTATION OF SUPER LONG FRONT MACHINE 6 6-44 PC130 - 7 (super long front) A Distance front end to swing centre (mm) 7810 B Distance swing centre to rear end (mm) 2110 C Overall height (mm) 2715 D Overall width (500 mm shoes) 2460 Overall width (600 mm shoes) 2560 Overall width (700 mm shoes) 2660