4.8 Service procedure Every 1000 hours service Maintenance 4.8.8 Every 1000 hours service Maintenance for every 50, 100, 250 and 500 hours service should be carried out at the same time. Change oil in transfer case z The parts and oil are at high temperature after the engine is stopped, and may cause burns. Wait for the temperature to go down before starting the work. z When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it. z Refill capacity: 4.4 liters (1.16 US gal) 1. Set a container to catch the oil under drain plug (P), then remove drain plug (P) and drain the oil.
To prevent the oil from pouring out suddenly, loosen drain plug (P) and remove it gradually. 2. After draining the oil, install drain plug (P). Tightening torque: 58.8 to 78.5 N·m (6 to 8 kgf·m, 43.4 to 57.9 lbft) 3. Loosen bolt (1), remove cover (2), then take out strainer (3). P 1 2 4. Remove any dirt stuck to strainer (3), then wash it with clean diesel oil or flushing oil. If the strainer is damaged, replace it with a new part. 2 5. Replace O-ring (4) of cover (2) with a new part, then install. GK015026 4 3 6. Refill the specified quantity of oil through oil filler (F). 7. After filling with oil, check that the oil is at the specified level.
For details, see "Check oil level in transfer case, add oil (4-29)". 8. Check that there is no oil leakage from the transfer case. F GK032288 4-56 WA150-5H – VEAM934100 WARNING WARNING