. OPERATION LONG TERM STORAGE LONG TERM STORAGE the machine in the DURING STORAGE WARNING 3 - 128 BEFORE STORAGE NOTICE When storing the machine (1 month or more), set NOTICE When storin posture sho wn in the diagram on the right to protect (To prevent r usting of the cylinder rod) When keep ing in long-term storage (more than one month), store as follows. Clean an d wash all parts, then store the mac hine indoors. If the machine has to b e stored outdoors , select level ground a nd cover the machine with canvas. m collecting. inder piston rod with grease. Fill the fu el tank. This prevents moisture fro Lubricat e and change the oil before storage.
Coat the exposed portion of the hydraulic cyl Disconn ect the negative terminals of the batte ry and cover it or remove it from the m achine and store it separately. Lock eac h control lever and pedal with the s afety lock lever and pedal lock. Set the s top valve to the LOCK position on m achines ready for attachments. Instal l the blind plugs t o the elbows. Set the selector valve on the machines which can install attachments to the "Crusher or general attachment" attachment" position. To preve nt corrosion, be sure to fill the coolin g system with Supercoolant (AF-NAC ) or permanent ty pe antifreeze (density between 30% and 68%).
If it is necess ary to perform the rust-prevention opera tion while the machine is indoors, open t he doors and windo ws to improve ventilation a nd prevent gas poisoning. Operate th e engine and move the machine for a short distance once a month so that a new film of oil w ill be coated over mova ble parts and component surfaces. A t the same time, also charge the battery For mac hines equipped with an air condition Rotate th e tracks. AFTER STORAGE NOTICE NOTICE If the machi ne has been stored without carrying out the monthly rust-prevention operation, consult your Komat su distributor before using it. When usin g the machine after long-term storag e, do as follows before using it.
er rods. Wipe off the grease from the hydraulic cylind Add oil a nd grease at all lubrication points. When th e machine is stored for a long period, moisture in the air will mix with the oil. Check the oil bef ore and after starting t he engine. If there is water in the oi l, change all the oil.