OM4054 09/11 Lubrication and Service - Section 40 Page 40-13 5000 HOUR INSPECTION Perform the maintenance items for the 250, 500, and 1000 hour intervals at this time, also. Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS 1 Engine Driveline Adapter - Inspect driveline adapter rubber dampers. If any defects are found, repair as required. 2 Front And Rear Drive Shafts - a. Grease the U-joints on each drive shaft. Refer to lube key F on the lubrication chart. b.
Inspect both front and rear drive shafts for binding, wear, vibration, etc. If U-joint dam- age or roughness is noted, both U-joints on a given shaft must be replaced. Refer to the service manual for replacement proce- dures. 3 Front Suspensions - Drain the front suspension oil. Disassemble and inspect the upper flange internal bearing. Replace any worn parts. Refill the suspen- sion with clean oil and recharge with nitrogen. Refer to the service manual for service information on the suspensions. 4 Prelub™ System - Inspect system components for damage, leakage, etc. 5 Body Guide - Inspect the body guide wear points for excessive wear and damage. Replace as necessary.